The current utilization of access to internet network is already widely used. Research results also gained some room located near some of the access point are having Signal More than one access point, while some other point still entered into the realm of blankspot. Reception on location observed is not the same, some point receive very strong signals from Experimental results indicate the quality of the The analysis performed includes: Signal level, Signal-toInterference ratio, and Quantity of Access point. The research method used was the experiment through the drive Territory of blankspot on that location, so that it can be used as a reference for optimizing the Lecturer electrical engineering building FPTK UPI 3 and 4 floors. Of the access point toward the receiver Wi-Fi in the room and the room of the student learning On the research of the simulation is done against the signal strength Installation of the access point is often not structured properly so that the area of scoped in theĪrea of coverage is uneven. Network is seen with the growing number of access points that are installed to meet these needs.

The requirement to always be connected to the internet Bandung, Currently the ease of accessing the internet has become a fundamental requirements

Series: Materials Science and Engineeringģ84 (2018) 012001 doi:10.1088/1757-899X/301Īnalysis of the Coverage Area of the Access Point Usingĭepartemen of Electrical Engineering Education, Universitas Pendidikan Indonesia, International Symposium on Materials and Electrical Engineering (ISMEE) 2017 This content was downloaded from IP address 95.181.182.138 on at 08:16 Optimization of Archeological Anomalies View the article online for updates and enhancements.

To cite this article: A T Suryani and A B Pantjawati 2018 IOP Conf. IOP Conference Series: Materials Science and EngineeringĪnalysis of the Coverage Area of the Access Point

Netspot ssid orange